Directed 1475 Kullanıcı Kılavuzu - Sayfa 7

Uzaktan Çalıştırıcı Directed 1475 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed 1475 12 sayfaları. 4­ button automatic / manual transmission remote starter

Sayfayı Yazdır
Directed 1475 Kullanıcı Kılavuzu
Idle Mode 
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
or
button on the transmitter until the parking lights come ON.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page-4); at the last step, the
buttons.
Note 1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
Note 2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode 
When the vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
The following feature will put your remote car starter into Valet Mode:
Ignition Valet:
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2.
The parking lights will flash 3 times.
3.
Turn the ignition OFF.
4.
The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
To take the system out of Valet mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2.
The parking lights will flash twice.
3.
Turn the ignition OFF.
4.
The LED on the antenna will be OFF.
User guide
, button to leave the doors locked and the starter kill armed.
This feature allows you to put your system into Valet Mode by using the
ignition key.
To put the system into Valet Mode 
To take the system out of Valet Mode 
button is pressed instead of the other
 
,
P. 7