Clarke CHG1600 Kullanıcı Talimatları - Sayfa 8

Elektrikli Alet Clarke CHG1600 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Clarke CHG1600 13 sayfaları. Hot air gun

REMOVING PAINT AND DISSOLVING ADHESIVES

The gun can be used in conjuction with a shavehook to remove paint.

1. With the switch in the '0' (OFF) position plug the hot air gun into the mains

supply.

2. Set the switch to either position 1

or 2 according to how much heat

is required. (see Specification on

page 2).

• Ensure the nozzle is pointing

away from you.

3. Bring the nozzle of the hot air gun

to the work piece approximately 3

cm from the surface.

• The exact distance between

the nozzle and the work piece will be dependent on the material

being worked on.

• Paint will rapidly become soft and blister, at which point it can be

removed with a suitable scraper. Do not allow paint to burn as this

will make the removal process more difficult.

• Some adhesives soften when heated and the joint can then be

separated, taking care to avoid damage to jointed parts.

4. Clean your shavehook quickly if paint/glue becomes stuck to it.

• Profiled parts may be cleaned with a suitable wire brush once paint

is softened.

• Normally only one pass is required to remove both thick and thin

layers of paint.

DO NOT point the gun directly at

glass and always ensure it is

adequately protected. A glass

protection nozzle is provided for use

when stripping window frames etc.

1. Fit the glass protection nozzle to

the front of the hot air gun and

angle it so that the gun can be

placed up against the window,

with the cowl of the nozzle, flat

against the glass as shown.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]