Clarke CHG1600 Kullanıcı Talimatları - Sayfa 9

Elektrikli Alet Clarke CHG1600 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Clarke CHG1600 13 sayfaları. Hot air gun

2. It will be necessary to change the position of the protection nozzle as you

work around the window pane. Ensure you wear adequate hand

protection when doing so.

3. The protection nozzle must be kept in contact with the work at all times, but

do not spend too much time in one area.

GENERAL USE

To prevent the gun from overheating, maintain a minimum distance of 3 cm

between the end of the nozzle and the work piece.

When bending or forming plastic parts, work slowly and with great care

observing the effects of heat on such materials.

NOTE: With plastics, the temperature range between solid, pliable and

liquid states is narrow, therefore great care should be taken.

Wood can be stained giving a 'rustic' effect.

1. Fit the diffuser nozzle to the front of the hot air gun.

2. Do not hold the nozzle too close to the wood as this may cause the wood

to colour unevenly.

3. Use a fine sandpaper to remove any singed wood fibres when finished.

Fit the concentrating nozzle to the front of the hot air gun.

1. Select a suitable size heat shrink sleeve for the work piece.

NOTE: Heat the sleeve evenly.

The gun is ideal for speeding up the defrosting of water pipes.

1. Always heat frozen areas inwards from the edge to the centre.

2. Take special care when defrosting plastic pipes.

3. Provide protection against heat damage to nearby paint and wall

coverings where necessary.

4. Be aware that copper gas pipes can be difficult to distinguish from copper

water pipes. Always check first.

5. Copper pipes are often soldered together, therefore should not be heated

above 200

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]