Zanussi ZOG10311XK Kullanıcı Kılavuzu - Sayfa 16

Fırın Zanussi ZOG10311XK için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZOG10311XK 25 sayfaları.
Ayrıca Zanussi ZOG10311XK için: Kullanıcı Kılavuzu (24 sayfalar)

Zanussi ZOG10311XK Kullanıcı Kılavuzu
Problem
The turnspit does not rotate.

SERVICE DATA

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

INSTALLATION

WARNING! Refer to Safety chapters.
GAS CONNECTION
WARNING! Before the gas
connection, disconnect the mains plug
from the mains socket or deactivate
the fuse in the fuse box. Close the
primary valve of the gas supply.
The gas supply ramp is on the rear side of the
appliance.
WARNING! Do not use rubber flexible
pipes!
Do not fully put the oven into the built-in cabinet
(approximately 30 cm).
Connection with a flexible metallic pipe or a
rigid metallic pipe:
16
Possible cause
The turnspit is not correctly in-
stalled into the turnspit hole.
We recommend that you write the data here:
Refer to "Using the accesso-
ries" chapter, Using the turn-
spit.
the oven cavity. Do not remove the rating plate from
the oven cavity.
.........................................
.........................................
.........................................
A
A. Gas supply ramp, end of shaft with ramp
B. Washer
C. Elbow
Put the supplied gasket between the pipe and the
gas supply ramp. Turn the pipe to the 1/2" gas
supply ramp.
1. Use a 22 mm spanner to tighten the nuts. Keep
the gas supply ramp in the correct position. Do
not apply force to the gas supply circuit.
WARNING! Do not use a flame to
check for leaks!
2. Fully move the oven into the built-in cabinet.
WARNING! Do not squeeze the
gas supply ramp and the pipe
when you move the oven into the
built-in cabinet.
Remedy
B C