Zanussi ZOG10311XK Kullanıcı Kılavuzu - Sayfa 18
Fırın Zanussi ZOG10311XK için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZOG10311XK 25 sayfaları.
Ayrıca Zanussi ZOG10311XK için: Kullanıcı Kılavuzu (24 sayfalar)
Sayfayı Yazdır
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a different
one, which is necessary for the type of gas you
use.
Refer to "Technical data" chapter.
6. Assemble the burner in a reverse sequence.
Replace the gas type sticker near the gas supply
ramp with the one related to the new gas type.
The gas oven burner does not need any primary
gas regulation.
Make sure that the gas supply
pressure of the appliance is in line with
the recommended values.
If the supply gas pressure is
changeable or different than the
necessary pressure, you must fit an
applicable pressure adjuster on the
gas supply pipe.
MINIMUM LEVEL ADJUSTMENT OF THE
OVEN BURNER
1. Disconnect the appliance from the electricity.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a thin-
bladed screwdriver.
Change of the
type of gas
From natural gas to
liquid gas
18
A
Adjustment of
the adjustment
screw
Fully tighten the
adjustment screw
in.
From liquid gas to
natural gas
4. Attach the knob for the gas control.
5. Connect the appliance to the electricity.
WARNING! Only put the mains plug
into the mains socket when all parts
are back into their initial position.
There is a risk of injury.
6. Light the gas oven burner.
Refer to "Daily use" chapter.
7. Set the knob for the gas control to the
maximum position and let the oven heat for at
least 10 minutes.
8. Turn the knob for the gas control from the
maximum to the minimum position.
Control the flame. If the flame goes out, do the
procedure again. There must be a small regular
flame on the oven burner crown.
The manufacturer objects liability if you do
not obey to this safety measures.
BUILDING IN
Only set up the appliance in a kitchen or in a
kitchen-dining room. Do not set up the appliance in
a bathroom or a bedroom.
You can install the appliance "built-in" or "built-
under". The dimensions of the built-in cabinet must
agree with the related illustrations.
Release the adjust-
ment screw ap-
proximately 1/3 of
a turn.