Zanussi FI 1073 Talimat Kitapçığı - Sayfa 9

Yıkayıcı Zanussi FI 1073 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi FI 1073 22 sayfaları. Washing machine fi 873 - fi 1073

a) Door

The dimensions of the door should be:

- width

595-598 mm

- thickness 16-22 mm

The height (C-Fig. C) depends on the height of

the adjacent furniture's base.

b) Hinges

To mount the hinges it is necessary to drill two

holes (dia. 35 mm, depth 14 mm) on the inner

side of the door. The distance between the holes

must be 416 mm.

The distance (B) from upper edge of the door to

the centre of the hole depends on the adjacent

furniture's dimensions.

The required dimensions are given in the picture

The hinges will be fixed to the door by means of

screws for wood (2-Fig. B).

c) Mounting the door

Fix the hinges to the machine by means of the

M5x8 screws (3-Fig. B). The hinges can be

adjusted to compensate for possible uneven

thickness of the door.

To align the door perfectly it is necessary to

loosen the screw (3-Fig. B), adjust the door and

tighten the screw again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic

closure of the door. To enable a correct operation

of this device, it is necessary to screw the

counter-magnet (6) (steel disk + rubber ring) into

the inner side of the door.

Its position must correspond to the magnet (4) on

the appliance (see picture D).

If the door has to be opened from left to right,

invert the position of the plates (7), the magnet

(4) and the rubber cap (5) (Fig. B and E). Mount

the countermagnet (6) and the hinges (1) as

previously described.

Important: the plastic screw (8) should never be

loosened (Fig. B and E).

P0226

P0984

P0983