Zanussi ZFT 710FW Talimat Kitabı - Sayfa 12

Dondurucu Zanussi ZFT 710FW için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Zanussi ZFT 710FW 16 sayfaları. Freezer zft 710fw

Ventilation Requirements

The appliance must have adequate ventilation to ensure

correct operation.

Diagram shows the ventilation requirements when

installed:

A* Under a worktop, or cupboard.

The clearance space of 10 cm above the appliance

may be reduced to 5 cm providing a clearance space

2.5 cm is left on either side of the appliance.

When freestanding

If required the door can be reversed, hinged from the left,

opening from the right.

To reverse the bottom hinge assembly proceed as fol-

lows:

Disconnect the appliance from the electricity supply.

Tilt the appliance backwards, resting the top edge of

the appliance on a stool or something similar.

Unscrew the 2 adjustable feet. Unscrew the 2

screws holding the lower door bracket, transfer the

lower door hinge pin to the alternative position as

shown in the top drawing. Unscrew the single screw

at the bottom left hand side and retain . Replace the

lower door bracket on the bottom left hand side but

do not fully tighten the 2 screws.

Remove the fridge door by gently pulling downwards

and store to avoid damage.

Unscrew the top door hinge pin of the refrigerator

then screw it back on the other side. As shown in the

second drawing.

Replace the fridge door on the upper door hinge pin.

Insert the lower door hinge pin into the door and tight-

en all screws.

Re-fix the retained screw to the bottom right hand

side and replace the 2 adjustable feet.

Lift the fridge back onto its feet and check it is set

level and the door seal meets the fridge all around the

door.

Transfer the handle to the opposite side and place the

plastic covering inserts, (supplied in the plastic bag of

this instruction book) into the holes set free.

Reconnect the fridge to the electricity supply.