Zanussi ZFT 710FW Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Морозильна камера Zanussi ZFT 710FW. Zanussi ZFT 710FW 16 сторінок. Freezer zft 710fw
Друкувати сторінку
Ventilation Requirements
The appliance must have adequate ventilation to ensure
correct operation.
Diagram shows the ventilation requirements when
installed:
A* Under a worktop, or cupboard.
*
The clearance space of 10 cm above the appliance
may be reduced to 5 cm providing a clearance space
2.5 cm is left on either side of the appliance.
B
When freestanding
Door Reversal
If required the door can be reversed, hinged from the left,
opening from the right.
To reverse the bottom hinge assembly proceed as fol-
lows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of
the appliance on a stool or something similar.
Unscrew the 2 adjustable feet. Unscrew the 2
screws holding the lower door bracket, transfer the
lower door hinge pin to the alternative position as
shown in the top drawing. Unscrew the single screw
at the bottom left hand side and retain . Replace the
lower door bracket on the bottom left hand side but
do not fully tighten the 2 screws.
12
Remove the fridge door by gently pulling downwards
and store to avoid damage.
Unscrew the top door hinge pin of the refrigerator
then screw it back on the other side. As shown in the
second drawing.
Replace the fridge door on the upper door hinge pin.
Insert the lower door hinge pin into the door and tight-
en all screws.
Re-fix the retained screw to the bottom right hand
side and replace the 2 adjustable feet.
Lift the fridge back onto its feet and check it is set
level and the door seal meets the fridge all around the
door.
Transfer the handle to the opposite side and place the
plastic covering inserts, (supplied in the plastic bag of
this instruction book) into the holes set free.
Reconnect the fridge to the electricity supply.