Blackberry Radar H2 Kurulum Kılavuzu - Sayfa 18

Radar Blackberry Radar H2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Blackberry Radar H2 30 sayfaları. Dry van, insulated trailers roll-up doors
Ayrıca Blackberry Radar H2 için: Kurulum Kılavuzu (33 sayfalar), Kurulum Kılavuzu (26 sayfalar), Kurulum Kılavuzu (25 sayfalar), Kurulum Kılavuzu (32 sayfalar), Kurulum Kılavuzu (33 sayfalar), Kurulum Kılavuzu (34 sayfalar), Kurulum Kılavuzu (35 sayfalar), Kullanım Kılavuzu (33 sayfalar), Kurulum Kılavuzu (32 sayfalar), Kurulum Kılavuzu (26 sayfalar), Kurulum Kılavuzu (25 sayfalar), Kurulum Kılavuzu (28 sayfalar)

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE

4. Insert the inner housing into the outer housing. Locate the fastener bag from Step 1.

Remove the two screws from the bag and use them to secure the housing.

The module is prepared for installation on the asset.

3.4.2 Installing the module on an asset

1. As indicated in Section 3.3 of this guide, record the module identifier and the asset

identifier the module will be paired with. For your convenience, you may quickly

create a record of the module and asset identifier pairings by removing the partially

attached label from the rear housing of the module and placing it on the installation

worksheet, next to the asset that will be tracked by the module.

Tip: For modules that have previously been transferred to new assets, the temporary

S/N label may no longer be in place. If this is the case, you will need to write the

module identifier (S/N) for each module on the installation worksheet.

The following sections of this guide will illustrate recommended installation

methods for various asset scenarios.