Alemite 7886-S5 Servis Kılavuzu - Sayfa 12
Su Pompası Alemite 7886-S5 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alemite 7886-S5 14 sayfaları. Medium-pressure stainless material pump
Sayfayı Yazdır
SER 7886-S5
With air pressure at zero:
6. Connect a product hose to the pump's material
outlet.
• Direct the hose into a collection container.
7. Place the pump in the product to be dispensed.
8. Slowly supply air pressure to the pump's motor
once again.
9. Allow the pump to cycle slowly until the product
is free of air.
If the pump assembly does not prime, refer to the
Troubleshooting Chart for details.
10. Inspect Packing Screw (12) for leakage.
Should the solution overflow the torque hole in the
Packing Screw, tighten the Packing Screw clockwise
1/8 turn.
With air pressure at zero:
11. Attach a control valve to the outlet hose of the
pump.
• Make sure the nozzle on the control valve is
open and pointed into an appropriate collection
container.
12. Slowly supply air pressure to the pump's motor.
13. Allow the pump to cycle slowly until the product
is once again free of air.
14. Set the air pressure to 100 psi (6.9 Bar).
15. Operate the control valve into the container
momentarily.
16. Shut off the control valve.
• Visually inspect the pump for external leaks.
• The pump should not cycle more than once or
twice in one hour.
Revision (8-00)
Medium-Pressure Stainless Material Pump
If the pump does not stall, refer to the Troubleshooting
Chart for details.
17. Check the motor for air leakage.
If the motor leaks, refer to the Air Motor Service Guide
for details.
18. Open the control valve and allow the pump to operate for 5
minutes.
19. Inspect Packing Screw (12) for leakage.
Should the solution overflow the torque hole in the Packing
Screw, tighten the Packing Screw clockwise an additional 1/8
turn.
IMPORTANT: After 8-10 hours of operation,
inspect the Packing Screw for leakage once
a g a i n . Ti g h t e n a n a d d i t i o n a l 1 / 8 t u r n a s
required.
Installation
Additional items that should be incorporated into the air
piping systems are listed in Table 5.
Part Number
338862
Moisture Separator/Regulator & Gauge Combination
5608-2
Moisture Separator
7608-B
Regulator and Gauge
5908-2
Lubricator *
Table 5 Air Line Components
* Although the air motor is lubricated at the factory, the life
of the motor can be extended with the use of a lubricator.
12
Description
Alemite Corporation