Alemite 7344 Servis Kılavuzu - Sayfa 4

Araçlar Alemite 7344 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alemite 7344 8 sayfaları. High capacity twin hose reel

Sayfayı Yazdır

SER 7343

WARNING

Release all pressure within the system prior to

performing any maintenance procedure.

Turn off the power supply.

Operate the hydraulic tool to relieve the remaining pres-

sure within the system.

Maintenance

Read each step of the instructions carefully. Make sure a

proper understanding is achieved before proceeding.

Delivery Hose Replacement

1. Extend the delivery hose completely from the reel.

WARNING

Precautions must be taken to ensure the

Sheave Assembly remains engaged with the Power

Spring's ratchet. To prevent movement either:

• instruct an assistant to grip the Sheave Assembly

securely with non-slip gloved hands or

• install a clamp on the Sheave Assembly

Personal injury can occur.

2. Remove the hydraulic tool and hose stop.

3. Disconnect the delivery hose from 90 ° Unions (22).

4. Remove Wing Nuts (16) and Washers (15) that secure

U-Bolts (14) to the hose.

• Remove the hose.

5. Feed the end of the new delivery hose through the Hose

Guide Assembly.

6. Connect the delivery hose to the 90 ° Unions.

HINT: Orient the hose to allow its natural curve

to match the Sheave. This reduces torque load on

Power Spring Assembly (26).

7. Secure the delivery hose to the Sheave Assembly with

U-Bolts (14), Washers (15) and Wing Nuts (16).

8. Install the hydraulic tool (with thread sealant) and hose stop

to the delivery hose.

IMPORTANT: Allow some slack on the hose

between the U-Bolt and the 90 ° Unions.

9. Pressurize the system and check for leaks.

10. Carefully release the Sheave Assembly and retract the hose

onto the reel.

11. Check the Spring Tension.

• Please refer to the section entitled Installation for details.

Revision (11-08)

1-800-548-1191-http://[email protected]

Disassembly

WARNING

Release the tension on the power spring. Per-

sonal injury can occur.

Power Spring, Arbor, and Sheave Removal

1. Remove the Arm and Hose Guide assembly from Base

Assembly (8).

2. Unscrew Swivel Stem (2e) from Shaft and Flange Assembly

(20).

3. Disassemble the Swivel Assembly as required.

• See Figure 3.

4. Remove Screws (12) that secure Power Spring Assembly (26)

to the Base Assembly.

• Remove the Power Spring Assembly.

5. Remove Retaining Ring (5) that secures Spring Arbor (27) to

the Shaft and Flange Assembly.

• Remove the Spring Arbor and Key (21).

6. Remove Nuts (3) that secure the Bearing and Housing

assembly to the Base Assembly.

Item #

Part No.

Ring, Retaining

Ring, Back-Up

X171009-17

O-Ring, 13/16 " ID x 1 " OD

Body, Swivel

340304

Stem, Swivel

X171009-18

O-Ring, 7/8 " ID x 1-1/16 " OD

Legend:

Part numbers left blank are not available separately

Part number with an X prefix indicates a quantity of ten (10)

designates the parts available in Repair Kit 393781

Figure 3

Swivel Assembly 340305 - Exploded View

High Capacity Twin Hose Reel

Description

Notes Qty

Alemite, LLC