Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION Kullanıcı Kılavuzu - Sayfa 6

Uzaktan Çalıştırıcı Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION 16 sayfaları. One-way fm automatic/manual transmission remote starter

Sayfayı Yazdır

neutral position.

2. With the engine already running, apply the

parking brake once and release the brake

pedal.

3. Within 20 sec. of engaging the parking

brake, press and hold

the transmitter.

The parking lights will flash 3 times quickly

and remain lit.

4. Remove the key: the engine will continue running.

5. Exit the vehicle and close all doors, hood and trunk.

6. Press for approx. 1 second either:

to lock the doors and shut down the engine;

to unlock the doors and shut down the engine;

to shut down the engine without affecting the doors.

7. The parking lights will flash twice to confirm ready mode activation.

Remote starting

Press the

button for approximately 1 second. The parking lights will turn ON to inform you that

the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will

start. The parking lights will remain

during the pre-programmed run time of the engine.

If your vehicle has an automatic transmission and it does not start at the first attempt, the system

will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts

before the system gives up.

Driving Off

With the vehicle running under remote control, press the

doors. Enter the vehicle and do the following:

Turn the ignition key to the

IGNITION ON (RUN)

while the engine is running. This would cause the starter motor to re-engage.)

Press the brake pedal to disengage the remote starter unit.

You are now ready to drive off.

Remote Starter Features

Remote Door Locks

If your system was installed with the Remote Door Locks option, you will have the convenience of

remote keyless entry.

To lock your doors and arm the starter kill (if installed):

Press and hold the

button for approx. 1 sec.

The parking lights will flash once to confirm that the doors have been locked

To unlock your doors and disarm the starter kill (if installed):

Press and hold the

button for approx. 1 sec.

P.6

2. With the engine already running, apply the

parking brake twice within 10sec.

Make sure to release the brake pedal.

The parking lights will flash 3 times quickly

and remain lit.

Skip to step 4.

button to disarm and unlock the

position. (Do not turn the key to the

CRANK

User Guide

position