Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Пульт дистанційного керування Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION. Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION 16 сторінок. One-way fm automatic/manual transmission remote starter
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
3. Within 20 sec. of engaging the parking
brake, press and hold
,
or
on
the transmitter.
The parking lights will flash 3 times quickly
and remain lit.
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either:
x
to lock the doors and shut down the engine;
x
to unlock the doors and shut down the engine;
x
to shut down the engine without affecting the doors.
7. The parking lights will flash twice to confirm ready mode activation.
Remote starting
Press the
button for approximately 1 second. The parking lights will turn ON to inform you that
the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain
during the pre-programmed run time of the engine.
ON
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
Driving Off
With the vehicle running under remote control, press the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Remote Starter Features
Remote Door Locks
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To lock your doors and arm the starter kill (if installed):
1.
Press and hold the
button for approx. 1 sec.
2.
The parking lights will flash once to confirm that the doors have been locked
To unlock your doors and disarm the starter kill (if installed):
1.
Press and hold the
button for approx. 1 sec.
P.6
2. With the engine already running, apply the
parking brake twice within 10sec.
Make sure to release the brake pedal.
The parking lights will flash 3 times quickly
and remain lit.
Skip to step 4.
button to disarm and unlock the
position. (Do not turn the key to the
CRANK
User Guide
position