Directed Electronics Xpresskit DBALL Kurulum Kılavuzu - Sayfa 8
Otomobil Aksesuarları Directed Electronics Xpresskit DBALL için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Electronics Xpresskit DBALL 14 sayfaları. Databus all combo bypass module
Ayrıca Directed Electronics Xpresskit DBALL için: Kurulum Kılavuzu (14 sayfalar)
Sayfayı Yazdır
Platform: DBALL
Firmware: GM5
Installation Type 5
OBDII (connector side view)
(+) 12v
(-) Ground
3: Green/White: (-) Door Status Output**
4: Red/Black: (-) Trunk Status Output**
5: Violet/White: (AC) Tach Output
*
Rear Hatch or Trunk Release Input
operation.
** If applicable - see the Function List.
Not required in D2D mode.
The Mobile Integration Systems
(+) Accessory Output
(+) Ignition 1 Output
(+) Ignition 2 Output
(+) Brake Input
Parking Lights
(AC) Tach Input
(-) Trunk Status Input**
(-) Door Status Input**
1
8
9
16
Diagnostic connector
2: Purple/Yellow: J1850
13: Red: (+) 12v
14: Black: (-) Ground
RF Loop Connector
Programming button
LED
: With vehicle with motorized rear hatch, this input will release the hatch. See programming options to change its
Vehicle CAN Bus Integration System
Ground
(-) Lock Output**
(-) Unlock Output**
(-) Rear Hatch or Trunk Release Output*
(+) Starter Output
(-) GWR (Status)
(+) Starter
10: Blue/White: (-) GWR (Status) Input
8: Violet: (+) Starter Input
Rear Hatch or Trunk Release Input*
3: Red/White: (-)
2: Blue: (-) Unlock Input**
1: Green: (-) Lock Input**
(+)12v
RX
(-) Ground
DBALL
TX
P#: XKD2D65
Rev.: 20101103
Hood Switch
(+) 12 V Input
© 2010 Directed Electronics. All rights reserved.
Page 8