Alemite 7340 Servis Kılavuzu - Sayfa 8

Kablolar ve konektörler Alemite 7340 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alemite 7340 12 sayfaları. High-capacity
Ayrıca Alemite 7340 için: Servis Kılavuzu (16 sayfalar)

Sayfayı Yazdır

SER 7340

Bench Test

While facing the Ratchet, turn the reel in a clockwise

direction and allow the Ratchet to latch the Pawl.

If the reel does not tension or latch properly, refer to

the Troubleshooting Chart.

Installation

WARNING

Do not exceed the lowest pressure rating

of any component in the system.

Never point a control valve at any portion of your

body or another person. Lubricant discharged at

high velocity can penetrate the skin and cause

severe injury. Should any fluid appear to puncture

the skin, get medical care immediately.

Ensure all components are in operable condition.

Replace any suspect parts prior to operation. Per-

sonal injury can occur.

Hold the delivery hose securely until the reel is

securely latched or fully retracted. Uncontrolled

retraction can result in personal injury.

Reel Mount

HINT: Should the reel mount to the ceiling

or a wall, it may be advantageous to lessen

its weight with the removal of the Power

Spring Assembly.

Follow the appropriate procedural steps

within the section entitled Overhaul.

Delivery Hose Description

3/8 " ID Two-Wire Braid

1/2 " ID Single-Wire Braid

1/2 " ID Air

Table 3 Delivery Hose Type and Length Comparison to Power Spring Tension in Number of Turns

Revision (2-03)

1. Mount the reel assembly with the proper hardware.

CAUTION

Never connect rigid piping to the Swivel assembly.

Damage to components can occur.

2. Screw a connecting hose (with thread sealant) into the

Swivel Assembly.

3. Attach the connecting hose to the supply line.

IMPORTANT: Anchor the connecting hose

to a suitable surface to prevent the hose from

flexing at the Swivel Assembly.

The anchor should be in-line with the inlet of

the Swivel to minimize side loading. See Fig-

ure 4.

Setting Power Spring Tension

4. Make sure there is no tension on the Power Spring

Assembly.

IMPORTANT: Wear non-slip gloves when

handling the Sheave Assembly.

5. While facing the Ratchet, turn the Sheave Assembly

clockwise to set the tension suggested for the type and

length of delivery hose used.

• See Table 3 for details.

6. Allow the reel to latch.

Length of Hose in Feet

100

High-Capacity Reel

Number of Turns

Alemite Corporation