LEGO 42031 Hızlı Başlangıç Kılavuzu - Sayfa 5

Oyuncak LEGO 42031 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. LEGO 42031 8 sayfaları. Tow truck

from the left.

Bag 14

Put the spectacles piece on its side, the handles to the right on top and bottom, and put the top ocular

hole (at the left) onto the long top connector at the right end of your structure.

Bag 15

Put a 13x1 oblong piece hor on your structure, from the front, putting its rightmost hole onto the same

long connector at the top on the right end of your structure.

Lay aside.

Bag 16. Make a part.

Insert a ridged stick into the cross-hole of a half-stick with the cross-hole, halfway in.

Put the F nuts on both ends.

Put a spectacles piece on its side, the handles to the right at front and back, and put it from the front on

the front end of the tick, with the cross-holes of the handles on the stick, and the ocular holes to the left.

Repeat symm at the back.

Insert four half-connectors from the top, long end first, into the ocular holes.

Put the four 1x1 buttons on tops of the half-connectors.

Turn this part so that the buttons are to the right at the top and the stick is upright to the bottom, and

connect to your main structure by inserting this stick inti the cross-hole at the right end of your structure.

Lay aside.

Bag 17. Make a part.

Put a F sector piece so that the curve is to the right and to the back.

Insert a ridged Philips stick upright from the top into the left back cross-hole.

Put a 2x1 oblong piece with its cross-hole on the stick, the round-hole end to the left.

Insert a ridged stick into the middle of a toothed wheel.

Connect this part to your main part by putting the back end of the ridged stick on the wheel (the wheel hor

at the front) into the round hole in the middle of the front edge of your main part.

Turn this part so that the F sector piece is at the back and put a F sector piece from the front, symm to the

similar piece at the back.

Connect this part to your main structure, as is, by putting the round-hole end of the part from the top on

the middle upright stick (to the top of the spiral part).

Bag 18

Connect this part firmly by pushing the vertical connectors from front and back all the way in.