LEGO 42031 Hızlı Başlangıç Kılavuzu - Sayfa 6

Oyuncak LEGO 42031 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. LEGO 42031 8 sayfaları. Tow truck

Bag 19

Put a F nut on the same stick.

Put a small toothed wheel on top.

Lay aside.

Bag 20. Make a part.

Put one connector with the hole in the middle ver on the table, the hole to left and right.

Insert the other such connector from the left into the hole.

Put a tube from the left hor on the left end of this part.

Put a F 7x1 oblong piece hor, upright, from the back, to this part, inserting the back vertical connector into

the rightmost hole of the 7x1 piece.

Insert a ridged stick a little bit into the leftmost cross-hole of a F 5x1 oblong piece. Turn this part hor,

upright, the stick on the left to the front, and connect to your main part from the back by inserting the front

end of the stick into the second hole from the right of the main part, and inserting the back end of the

right-end connector into the second hole from the left of the 5x1 piece.

Insert a long connector from the front, ver, short end first, into the leftmost hole of your part.

Put a 2x1 oblong piece on the front end of the same connector, the round hole on the connector and the

cross-hole to the left.

Put a F 7x1 oblong piece hor, upright, from the front, on your piece, symm to the similar piece at the back.

Make a part. Put a two-cross-holes piece hor, the large cross-hole at the right, from top to bottom, and the

small one to the left. Put an attached connectors piece so that one end is to the right and the other to the

top, and insert the right one, from the left into the left cross-hole. Insert a ridges Philips stick upright, from

the top, into the right cross-hole.

Turn this part upside down and connect to your main part by inserting the bottom end of the ridged Philips

stick into the cross-hole at the left end of the main part.

Connect this part to your main structure by turning it ver, the protruding F 5x1 oblong piece to the left at

the front, and putting the front hole of this part, from the left, onto the ridged stick at the left side of your

structure (turned ver, curved pieces to the front), on the sector piece.

Bag 21.

Turn your structure hor, the curved pieces to the left.

Put a F 5x1 oblong piece hor at the front, symm to the similar piece from step 11, bag 21, at the back.

Lay momentarily aside.

Bag 22. Make a part.

Put a 2x1 oblong piece hor on the table, the round hole to the left, from front to back.