Armstrong s-57 Kurulum ve Kullanım Talimatı - Sayfa 4
Su Pompası Armstrong s-57 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatı indirin. Armstrong s-57 10 sayfaları. In-line ecm circul ating pumps
Ayrıca Armstrong s-57 için: Kurulum ve Kullanım Talimatları (2 sayfalar)
Sayfayı Yazdır
i nstal latio n &
operati ng instruction s
4
warning
A poor electrical connection can overheat and cause
terminal and/or terminal board failures. Examine the
wiring harness quick- connect terminals carefully for
any signs of physical deterioration or loose fit to the
terminals on the motor terminal board.
Care must be taken to assure connections are made
to the proper terminals and adequate electrical clear-
ances are maintained.
warning
The control unit on the motor contains potentially
hazardous voltage.
caution
Wear safety glasses to inspect the equipment while
it is running, especially if cover plates are removed.
notice
• Voltage symbols vary among different multimeters and
may be displayed as V AC, AC, V, or a V beneath a wavy
line. Select the correct symbol and set the multimeter to the
voltage closest to the voltage you are measuring.
• Read all instructions thoroughly and be familiar with the
equipment before installing or working on it.
• The PerfectSpeed® motor is properly packaged for ship-
ment and storage and should be kept in a clean and dry
indoor area.
Overview
The interface board communicates with the motor control to
operate the motor in speed mode. The operating parameters
are programmed in the eeprom of the motor control, not the
PerfectSpeed® User Interface. On power up the interface board
extracts the operating parameters from the motor control.
Parameter categories include:
• Motor direction
• Motor mode of operation
• Motor output display
• Motor profile
In-line circulating
pumps
PerfectSpeed® user interface box
The PerfectSpeed® operates in speed mode when connected to
the pump. You can adjust the demand of the motor manually
using the PerfectSpeed® User Interface. The motor information
displayed in the User Interface is outlined in Table 1. If the
motor encounters a problem, the User Interface displays a
corresponding error code. These are outlined in Table 1 as well.
Table 1 – User interface display information
Control mode
Data displayed
Speed
Spd – followed by the instantaneous speed in rpm
(speed feedback)
dE – followed by S + demand in %
Error Codes
e1 – No communications
e2 – Under Voltage
e4 – Non- PerfectSpeed(r) Motor
Minimum and maximum operating parameters
The PerfectSpeed® motor operates properly within minimum
and maximum parameters. Your settings must be within these
ranges.
Table 2 – Armstrong centrifugal pump & motor operating
parameters
Control mode
Minimum
Speed
300 rpm
Maximum
s&h 5&6 series