Dish Network VideoPath DP21 Kurulum Kılavuzu - Sayfa 6
Anten Dish Network VideoPath DP21 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dish Network VideoPath DP21 19 sayfaları. Multi-dish switch
Ayrıca Dish Network VideoPath DP21 için: Kurulum Hızlı Referans Kılavuzu (6 sayfalar)
Sayfayı Yazdır
2.
Connect the coaxial cables from a DISH 500 or a DISH 300 to the
ports on the DP21 switch labeled To Dish as shown in the wiring
diagrams that begin on page 10.
Connect the cable from the satellite receiver port labelled Satellite
3.
In to the DP21 port labeled To Receiver Satellite In.
Run Check Switch
After you have connected cables and DP21 Switches to all receivers in
the system, run Check Switch on each receiver in your system, one at a
time. To do this, follow these instructions which apply to most receivers
or consult your user guide:
Select the Main Menu, then System Setup,
1.
Installation, and Point Dish/Signal.
A Point Dish/Signal menu similar to the one shown as Figure 1
2.
on page 7 will open.
Select Check Switch. The Check Switch screen will open.
3.
Select Check.
6