Aerial Ascent 2.0 Kurulum Kılavuzu - Sayfa 6

Tekne Ekipmanları Aerial Ascent 2.0 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Aerial Ascent 2.0 7 sayfaları.

STEP 7

steP 8

STEP 9

remove the tower from the boat and drill the holes with your 5/8"

drill bit. after your holes have been drilled, remove the masking

tape from the rear mount location.

Then place the tower back on the location with a rubber

mounting plate between the tower mount and the deck

surface. on the underside of the deck a backing plate

will also need to be installed.

Note: In the case where the deck of your boat is less then

1/4" thick, a reinforcing kit is required to thicken and rein-

MoUnT

force the deck in the mounting locations.

nylon WashEr

once the mount and its pats are assembled they can

rUBBEr

then be secured in position with a wrench.

BoaT DEck

Note: When folding the tower the mounts will rotate on the

rEInforcEMEnT

surface of the deck. When fastening the mount to the boat

deck, ensure that the mount is securely tightened in posi-

BackInG plaTE

tion but not overly tight that it will prevent the mount from

WashEr

rotating.

nylon lock nUT

Attach the rear bars to the front bars with the mounting fittings and

fasteners supplied.

all mounts are designed to swivel to ensure a square and even

installation.

Once all the fittings are correctly aligned they must then be firmly

secured in position with an allen wrench. We recomend using a

loctite Threadlocker during the installation of these fasteners.

GUIDE#: BT-ascEnT-001