CAME ZA3P Kurulum Kılavuzu - Sayfa 9

Kontrol Paneli CAME ZA3P için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. CAME ZA3P 13 sayfaları. Control panel for 230vgearmotors
Ayrıca CAME ZA3P için: Kurulum Kılavuzu (13 sayfalar)

Sayfayı Yazdır

functions selection

Selector

1 ON

Automatic closing activated (1 OFF - deactivated);

2 ON

"Open-stop-close-stop" with button (2-7) and radio-control

(AF card ﬁ tted) activated;

2 OFF

"Open-close" with button (2-7) and radio-control (AF card

ﬁ tted) activated; 3 ON

(AF card ﬁ tted) activated (3 OFF-deactivated);

4 ON

Pre-ﬂ ashing while opening and closing activated (4 OFF-

deactivated)

5 ON

Obstruction detection activated (5 OFF-deactivated);

6 OFF

"Maintained action" (excludes functioning of the radio

control) deactivated (6 ON-activated);

7 ON

Ram-jolt activated; with each opening command, the

gate-leaves at ﬁ nal closing point press for one second,

thus facilitating the releasing of the electrolock which

is connected to terminals 11-S. It is active only if the

gate-leaves are closed and the end of the working time,

or at the 1st maneuver after powering up the system (7

OFF-deactivated);

8 OFF

Terminal CX activated (8 ON-deactivated);

9 OFF

Ten-second slow-down deactivated (9 OFF.-activated);

10 ON

Photocells test activated (10 OFF deactivated).

Trimmer adjusting

Adjusting working time from a minimum of 10 seconds to a

maximum of 120 seconds.

Adjusting the automatic closing time from a minimum of 1

second, to a maximum of 120 seconds.

Adjusting delayed closing of 2nd motor (min. 0", max. 15")

and simultaneously partial opening (min. 0", max. 30").

Adjusting slow-down speed

To adjust the slow-down speed (operation to be done with gate stopped):

•

set DIP-switch 6 to ON;

•

press CH1, the red LED

(see table);

•

by pressing CH1 again it shifts to the next speed;

•

confirm the choice by pressing CH2;

•

reset DIP-switch 6 to OFF.

"Open only" with radio-control

will show the set slow-down speed

Selector

1 ON

Limit switches enabled (1 OFF -

disabled);

2 OFF

CX with reclosing during opening

feature.

2 ON

CX with partial stop feature.

Flashing in quick

succession

minimum

medium

maximum

L2T

L1T

12 24

L1T

L2T

0 12 24

FA1

FC1 FA2 FC2

E E3

TS 10

10 11

3 3P 4

2 C1 CX B1 B2

L2T

L1T