3Doodler Create+ Kullanıcı Kılavuzu - Sayfa 2
Aksesuarlar 3Doodler Create+ için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3Doodler Create+ 11 sayfaları.
Ayrıca 3Doodler Create+ için: Kullanıcı Kılavuzu (16 sayfalar)
Sayfayı Yazdır
SECTION 2: GETTING STARTED
We created this User Manual
as a step-by-step guide to
get you comfortable with
your 3Doodler Create+ and
its features. Once you are
familiar with these steps, you
will be able to Doodle with
confidence.
STEP 1:
Turn on your
3Doodler Create+
and wait for it to
heat up
02/2022
Speed/ Drive
Controls
SPEED/ DRIVE BUTTON
LEGEND:
• Click once to start
• Click once to stop
• Double click to reverse
LED Light
Tells you when your
3Doodler Create+ is
ready to use
LIGHT LEGEND:
SOLID RED:
Pen is heating up
GREEN: Ready to Doodle with
PLA/ WOOD
BLUE: Ready to Doodle
with ABS/FLEXY
FLASHING GREEN/BLUE:
Reversing plastic
How it Works:
The 3Doodler Create+ melts plastic filament and uses a motor and gears
to push it through the pen's nozzle in a thin line. This process is called
extruding or extrusion, and we will refer to it throughout this user
manual. Once extruded, the filament cools and hardens quickly, allowing
you to draw on surfaces and in the air. This user manual will show you how!
1
Power Adapter
Plug the power adapter into
the yellow hole at the back of
the pen.
Nozzle
Hot tip where filament is
extruded
Power Adapter
2
Slide the control switch to
PLA
(or your desired filament
setting).
SECTION 2: GETTING STARTED
Maintenance Cover
Allows you to look inside
your pen to see filament
Control Switch
For turning the 3Doodler
Create+ ON/OFF, and
selecting
PLA
or
ABS/FLX
extrusion temperatures
Plastic Loading Port
Insert your filament
strand here
3
60-90
secs
Light to
GREEN
The LED light will glow
RED
while the pen is reaching the
required temperature. Once the
light has turned GREEN, your
pen is ready to extrude.
2
EN