3DUpFitters Prusa i3 MK2 Kurulum Kılavuzu - Sayfa 11

Muhafaza 3DUpFitters Prusa i3 MK2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3DUpFitters Prusa i3 MK2 11 sayfaları. Enclosure kit
Ayrıca 3DUpFitters Prusa i3 MK2 için: Kurulum Kılavuzu (18 sayfalar)

Sayfayı Yazdır

9. MMU2/MMU2S

The Prusa enclosure for the MMU2/MMU2S

is taller so there is room inside for the

MMU2/2S unit. It also contains 4 extra

grommeted exit holes to run the PTFE

tubes from the ﬁlament spools or detangler

box to the top-mounted multi-material

extruder.

The top grommet holes are for people who

are storing ﬁlament rolls in an above

cabinet or on the wall behind the printer.

The back grommet holes are for people who

will be placing the ﬁlament on the table directly behind the printer.

10. DIY Tool Holder

Our favorite customization is to add magnetic tool

holders to the side. One end can be attached via

the same hole as the corner connectors, but the

other end will require drilling a single hole.

You can ﬁnd magnetic strips like this all over

Amazon or your local hardware store.