3DUpFitters Prusa i3 MK2 Kurulum Kılavuzu - Sayfa 9

Muhafaza 3DUpFitters Prusa i3 MK2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3DUpFitters Prusa i3 MK2 11 sayfaları. Enclosure kit
Ayrıca 3DUpFitters Prusa i3 MK2 için: Kurulum Kılavuzu (18 sayfalar)

Sayfayı Yazdır

supply, both cooling the power supply and heating the air as it enters. Even without a

fan, the power supply is still cooler this way because one side is exposed to colder air.

The right side panel is a little tricky to conﬁgure because

Prusa now has used two diﬀerent sizes of power supply.

The default layout is for silver power supply they've

used for years. Just make sure the cutout in the vent is

on the bottom half to ﬁt around the small bump at the

bottom 1/3 of the supply.

If, however, your power supply is black, you've got one

of new ones. In that case you'll want to run its power

supply cord through the black grommet directly to the

right of the vent. You'll also notice a gap between

the bottom of the power supply and the vent. This

can be plugged with a "Prusa gap ﬁllter" piece.

With the vent adapter in place, you can now attach

the last panel onto the enclosure.

6. Sealing Gaps

Once the enclosure is completely put together, it is time to make sure that each of the

panels is held tightly to each adjoining panel. The connectors are designed with a

small amount of play that allows you to make small adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel.

Repeat the process, going around the enclosure looking to make sure all of the panels

are ﬂush to each other.

Once the gaps are sealed, you can then position the enclosure. The biggest thing to

get right is to sit the power supply vent right next to the power supply. There isn't