ESi Ergo VICTORY 2VT-C48-24 Series Talimatlar Kılavuzu - Sayfa 3
İç Mekan Mobilyaları ESi Ergo VICTORY 2VT-C48-24 Series için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. ESi Ergo VICTORY 2VT-C48-24 Series 8 sayfaları. 2 leg electric table base
ASSEMBLY
STEP 1
With the table top facing down on a soft, clean
surface, arrange the cross channels and top
supports as shown.
• Positioning does not need to be exact at this time.
• Mounting tabs on the cross channels face inward,
toward each other.
• Holes on the top supports are offset to the rear.
STEP 2
Use an 5mm Allen key to loosen the M10 set screws
on the cross channels (two on each side of center).
STEP 3
Adjust the cross channels to their approximate final
lengths, as shown.
• Center the inner piece in each cross channel.
STEP 4
Attach the side legs to the cross channels and top
supports with six M8x12 screws per leg.
• Use a 5mm Allen key.
• Two screws attach to each cross channel and
two screws attach to the top supports.
STEP 5
Attach a foot plate and foot to each of the side
legs with the M6x35 screws.
• First, place the foot plate onto the leg with the
smooth side up.
• Position the foot over the foot plate, as shown.
The short side of each foot should face the rear.
• Screw the foot securely in position using a 5mm
Allen key.
VICTORY 2 LEG ELECTRIC TABLE BASE
Cross Channel
Mounting Tab
Loosen
Set Screws
Center
Inner Piece
Rear
Foot Plate
Top
Support
M8x12
M6x35
Front
Side
Legs
3