ESi Ergo VICTORY 2VT-C48-24 Series Talimatlar Kılavuzu - Sayfa 5
İç Mekan Mobilyaları ESi Ergo VICTORY 2VT-C48-24 Series için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. ESi Ergo VICTORY 2VT-C48-24 Series 8 sayfaları. 2 leg electric table base
Sayfayı YazdırASSEMBLY
STEP 11
Make connections to the control unit and motors.
• Connect the cable from the digital keypad.
• Connect the motor cables to the control unit and
to each of the motors on the table legs.
• Connect the power cord to the control unit.
• Plug the power cord into an AC outlet.
CAUTION: Do not operate the table until after "zero
setting" the system. See following step.
STEP 12
"Zero set" the system before testing operation.
• Press DOWN t to lower the legs to their lowest
position. (Note that with the table upside-down,
the DOWN arrow faces up).
• Press DOWN t again for about five seconds.
The legs will move further down slightly to their
absolute lowest position. Release the DOWN t
button.
• Press the UP s and DOWN t buttons to test
operation. End your test with the legs lowered
and unplug the power cord.
• If there are problems with operation, check that
all cable and cord connections are secure. If
problems continue, call ESI Customer Service.
STEP 13
Use the cable clamps and ties to secure the cables
in position.
• Cables must not interfere with table operation.
• Cables must not interfere with the user.
STEP 14
With the assistance of a helper, turn the table
upright and place it in its final position.
IMPORTANT: There must be 1" (25mm) of clearance
on all sides of the work surface (and other moving
parts) to ensure free, unobstructed movement.
• Adjust the leveling glides on the feet to level the
work surface, if necessary.
• Plug the power cord into an AC outlet.
• See the following pages for operating
procedures.
VICTORY 2 LEG ELECTRIC TABLE BASE
Keypad
Cable
Motor
Cables
DOWN
Button
Power
Cable
Cable Management
5