Altocraft 241-9902 Operatör El Kitabı - Sayfa 4

Matkap Altocraft 241-9902 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Altocraft 241-9902 9 sayfaları. 18v cordless drill & worklight kit

Sayfayı Yazdır

FUNCTION DESCRIPTION

Worklight

1. Swivel Head

2. Switch Trigger

3. Handle

Coreless Drill

1. 3/8" Keyless Chuck

2. Trigger Switch

3. Battery Pack

4. Battery Release Button

5. Screw Bit

6. Direction Lever(Forward /Stop /Reverse)

7. Torque Adjustment

OPERATING PROCEDURES

VARIABLE SPEED

You can vary the spindle rotation speed by modulating the ﬁnger pressure on the

trigger. Light ﬁnger pressure causes the drill speed to be slow; heavier pressure

will produce a higher drill speed.

ROTATION DIRECTION

Your drill is equipped with a 3-position forward/reverse switch through the housing

above the trigger.

1. When the knob is pushed toward the right, the rotation is reversed (counter-clockwise).

2. When pushed in from the right to the left side, the rotation is forward (clockwise).

3. When in center position, it is locked in neutral and the trigger is blocked. Do not

push the rotation direction knob until the chuck stops turning.

TORQUE REGULATOR

This is a 20 position dial situated just before the chuck.

•

When the indicator reads 1, the torque is at a minimum before the clutch disengages

the chuck from the drive.

•

When the indicator is just past 19, the output is at maximum before it is disengaged.

This is useful in driving screws into different types of material.

•

More torque sets a screw deeper into material, less torque will prevent it from strip-

ping. Larger screws require more torque than smaller screws. A little trial

and error will show you which is the optimum setting for the situation.