Altocraft 241-9902 Operatör El Kitabı - Sayfa 6
Matkap Altocraft 241-9902 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Altocraft 241-9902 9 sayfaları. 18v cordless drill & worklight kit
The battery discharges slowly over time, even when not used, and may require
After many charge/discharge cycles, your battery will lose its ability to hold a
!
WARNING! Never charge the battery until it is cooled down, charging the hot battery may
cause the battery to explode.
WARNING! Dispose of batteries at an appropriate waste disposal facility. They
!
contain cadmium, so do not throw the batteries away in common trash
receptacles. CALL 1-866-915-8626 FOR ADVICE.
Keep the tools clean using a soft, damp (not wet) cloth. Do not use solvents on
Lubrication is not necessary. After long use, have an authorized service center
Should the drill chuck require replacement:
1. Remove the battery pack
2. Open the chuck jaws as widely as possible so you can access the chuck retain-
3. Unscrew the chuck retaining screw with a philips screwdriver. Note that this is a
4. Clamp the shorter arm of a large allen wrench in the chuck, aligning it with the
5. Place the drill on a flat surface, and support the chuck with a piece of wood
6. Strike the long arm of the wrench with a hammer so that the chuck turns
7. Repeat the process in reverse to install a new chuck.
•
To maintain the best performance of your rechargeable NiCd battery, prevent
it from overheating, both from overcharging and during storage. Occasionally
charge the battery for 6 hours. The battery may also benefit from a full discharge
from time to time.
OPERATING PROCEDURES
recharging before you use the tool.
charge. It should then be replaced.
MAINTENANCE
the plastic parts.
maintain and lubricate the tool.
ing screw.
left-hand-threaded screw and you must remove it by turning it clockwise.
jaws so they grip three of its six flat sides.
about 8mm or 3/8" above the surface.
counter-clockwise and unscrews from the spindle.
This may require a fairly sharp blow.
5