Altocraft 240-2087 Operatör El Kitabı - Sayfa 7

Testere Altocraft 240-2087 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Altocraft 240-2087 10 sayfaları. 8-1/4 inch compound miter saw

Sayfayı Yazdır

MAINTENANCE

ALIGNING MITER AND BEVEL

Miters and bevels have been set at the factory. However, use may effect settings.

Please use the following procedures when your tool needs adjustments.

Miter Angle

1. Set the bevel angle at 0 degree.

2. Loosen the locking handle.

3. Depress the miter detent spring lever.

4. Turn the saw table so that the arrow in the kerf plate points to 0 degree, then

move the table slightly clockwise and counter-clockwise and let the miter de-

tent spring lever fit into the groove (it doesn't matter if needle doesn't indicate 0

degree ).

5. Loosen the four hex bolts behind the fence with the blade socket wrench.

6. Lower the saw head and lock it in place with the head lock button.

7. Use the clear plastic setup triangle to check that the saw blade and the fence

are square. Move the fence a few millimeters to achieve this if

necessary.

8. Tighten the hex bolts in the fence firmly.

9. Confirm that the arrow in the kerf plate points to 0 degree. If not, loosen the

two screws in the bottom of the miter detent spring lever and adjust accord-

ingly.

Bevel Angle

A. Vertical stop: 0 degree adjustment

1. Lower saw head to lowest position and lock it with the head lock button.

2. Loosen the bevel lock handle on the back of the saw.

3. Check that the blade is perpendicular to the table as measured by the clear

plastic setup triangle. If not :

Use an open-end wrench to loosen the hex lock nut at the back left side

of the table.

b. Turn the bolt counter-clockwise and the 0 point moves left, closing the angle.

Turning it clockwise moves the 0 point to the right, opening the angle.

c. When you have established the vertical stop correctly, tighten the lock nut

to hold the setting.

d. Make sure that the needle points to 0 degree on the scale. If not, loosen

the screws and adjust the needle.

B. Bevel stop: 45 degrees adjustment

1. Lower the saw head to lowest position and lock it with the head lock button.

2. Loosen the bevel lock handle on the back of the saw.

3. Check that the blade is at 45 degrees to the table as measured by the clear

plastic setup triangle. If not :

a. Use an open-end wrench to loosen the hex lock nut at the back left side

of the table.

b. Turn the bolt clockwise and the 45 degrees point moves left, opening the angle.

Turning it counter-clockwise moves the 45 degrees stop to the right, closing

the angle.

c. When you have established the 45 degrees stop correctly, tighten the lock nut

to hold the setting.

d. Make sure that the needle points to 45 degrees on the scale. If not, loosen the

screws and adjust the needle.