ClearSpan 108986 Manuel - Sayfa 10

Sera Kiti ClearSpan 108986 için çevrimiçi göz atın veya pdf Manuel indirin. ClearSpan 108986 17 sayfaları. End frame kit 36' wide x 16' 2" high

Sayfayı Yazdır

CLEARSPAN

END WALL FRAMING KITS

™

END PANEL INSTALLATION (continued)

Cut Door Openings (Door installation only; additional door purchase required.)

ATTENTION: For best results and to keep the stretched panel in position, install Tek screws and washers from the outside

around the door frame to secure the end panel to the door jambs and header. (See dashed lines Fig. 1.) Do this before

cutting the opening in the panel. If you do not want to install screws through the panel, continue with Step 1.

These steps describe one way to cut a door opening:

ATTENTION: Do not cut door openings if you are not

installing doors.

1. Working from inside the frame, mark a 12"-16" border

along the door jambs and below the header. (Consult

the diagram below.) These 12"-16" flaps are wrapped

around the door framing and secured to the inside of

the door frame once the final diagonal cuts are made.

2. Using the diagram as a guide, cut the end panel to

remove the section that is shaded.

Wrap this portion

of the end panel

around and

secure it to the

door frame using

Tek screws and

washers. See

Step 1 in the next

procedure.

Door Jamb

END PANEL

12"-16"

Horizontal Conduit

used to stretch the

end panel during

installation.

Base Rail

Diagram above shows the end wall and end panel as seen from inside a similar shelter.

3. Make two (2) diagonal cuts in the end panel as shown above to create the 12"-16" flaps.

4. Continue with the next procedure.

Example Door Opening

(Can be used on any size door)

Step 3 Cut

Remove this dark shaded

portion of the end panel

material to create an opening

for the overhead door.

Ground Level

FIG. 1

12"-16"

Header

Door

Jamb

END PANEL

12"-16"

Horizontal

Conduit

Base Rail

Revision date: 11.12.14