ClearSpan 108986 Manuel - Sayfa 11

Sera Kiti ClearSpan 108986 için çevrimiçi göz atın veya pdf Manuel indirin. ClearSpan 108986 17 sayfaları. End frame kit 36' wide x 16' 2" high

Secure the End Panel to the End Frame

The frame shown in the following diagrams may differ from the actual frame. Installation steps are the same.

1. With door openings cut, secure the end panel to the door frame using Tek screws and washers. See diagram below.

NOTE: For the exposed corners of the door frame that remain, cut out a 16" x 16" piece of material from the scrap

end panel material and secure the piece to the exposed corners using Tek screws and washers (if desired).

Secure the end

panel to the inside

surface of the

End Panel

frame tube using

a Tek screw and

washer.

View shows the

inside surface of

the installed end

panel.

Install Tek

screw here

ATTENTION: DO NOT secure the end panel to the inside or backside of the door frame tubes. Some doors kits use

this surface for tracks and brackets. Check the instructions that shipped with the door for additional details.

2. Repeat the steps to install the end wall and end panel for the remaining end of the building if equipped.

3. Install the door or doors according to the instructions included with those components.

4. After doors are installed according to the door manufacturer's instructions, continue with the next procedure to

reattach the bonnet ratchets and main cover.

Revision date: 11.12.14

Door Jamb

CLEARSPAN

END WALL FRAMING KITS

™

Inside View

Outside View

Base Rail