ArtFox SKY BEAM 9R Kullanıcı Kılavuzu - Sayfa 4

DJ Ekipmanları ArtFox SKY BEAM 9R için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ArtFox SKY BEAM 9R 16 sayfaları.



strobe macro control available.



Lens optical system achanical fouce .beam angle 0～4°



Over heat protection



Power Input: 100-240V，50/60Hz



Power Dissipation：400W



IP level :IP20



Magnetic ballast and AC/Dc power supply



Product Size：45*43*57cm



Packing Size: 69*44*71cm



Net weight：15.5KG

Cable connection（DMX）

Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic

impedance, 22-24 AWG, low capacity. Do not use microphone cable or other cable with characteristics differing

from those specified. The end connections must be made using XLR type 3 or 5-pin male/female connectors. A

terminating plug must be inserted into the last projector with a resistance of 120Ohm (minimum 1/4 W) between

terminals 2 and 3.

IMPORTANT: The wires must not make contact with each other or with the metal casing of the connectors.

The casing itself must be connected to the shield braid and to pin 1 of the connectors.

This equipment can be positioned and fixed by clamp in every direction of the stage. Locking

system makes it easy to fasten to the bracket.

Attention! Two clamps is needed to fix the equipment. Every clamp is locked by fastener of 1/4

kind. Fastener can only be locked clockwise.

Attention! Fasten a safety string to the additional hole of side aluminum piece. The secondary

accessory can not hang on the delivery handle. Nip the equipment on bracket.



Check if rigging clamp (not including the one inside) damaged or not? If stand ten times

weight as the equipment. Make sure the architecture can stand ten times weight as all the

Figure 1 DMX Cable connection

Page 4