ArtFox SKY BEAM 9R Kullanıcı Kılavuzu - Sayfa 8

DJ Ekipmanları ArtFox SKY BEAM 9R için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ArtFox SKY BEAM 9R 16 sayfaları.

Set DMX Address

Click and select the "ADDR", can enter the page of DMX address setting, range from 1 to 512, the

address code shouldn't is not greater than (512- channels quantity), otherwise the light will not

been controlled. Following is the operation:

Enter the page of DMX address, as shown in Figure 7, click the blank area in right side of display

will pop-up diglog as in Fig. 4, modify value, then click 'ENTER' to confirm and save DMX

address code.

Enter the page of 'WORK MOD' as shown in Figure 8 and modify setting. Can set light work

mode, control lamp and DMX channel mode..

Light includes 3 work mode: DMX MODE, AUTO RUN and SOUND MODE, Parameter

definition as following:



DMX Mode：Under this mode, the light receive data from the DMX controller and move.



AUTO RUN：Under this mode, light will run with inside code(data), ignore data from DMX

controller.



SOUND Ctrl：Under this mode, light ignore data from DMX controller., When there is a

strong sound in stage, the light will run a scene, otherwise it will keep the last scene.



M/S Choose：'M/S Choose' is available when light just in 'AUTO RUN' or 'SOUND Ctrl'

mode. If this item is set as 'OFF', the light don't send data to other light via DMX Cable.

When 'ON', the data will send to other slave light immediately.



Lamp control：Turn on lamp when this item is set 'ON', otherwise, turn off lamp. The gap

between operation is limited to 30 second.



Channel mode：Light support 2 DMX Channel mode: sample or extend。

Figure 7 page of DMX Address

Figure 8 page of work mode

Page 8