Altronic GTI Bi-Fuel Kurulum ve Kullanım Kılavuzu - Sayfa 4

Kontrol Sistemleri Altronic GTI Bi-Fuel için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Altronic GTI Bi-Fuel 4 sayfaları. Form gti+ agv5 terminal program iom 1-15

Sayfayı Yazdır

2.2 Once the setup information is correct, select OK

Once Bi-Fuel is ON and the AGV5 is powered, communication should be

established. TD and RD on the adapter will blink frequently. If TD or RD is a

solid light, there is a communication error.

3.0 Understanding the Home Screen

3.1 Connection — The Connection key allows the user to select a new computer

communication port and protocol. The Baud Rate should be set to 9600, Parity

set to None, and Packet Delay set to 100.

3.2 ResetComStats — In the event of an AGV5 power off-to-on event

(commissioning and moving to a new load point), ResetComStats can be used

to reset communication with the AGV5 without closing the terminal program or

redoing the Connection protocol.

3.3 Disconnect — The Disconnect key breaks the communication link between the

AGV5 and the computer in use.

3.4 Chart — The Chart key allows the user to display the AGV5 functions in

graphical form.

3.5 SnapShot — The SnapShot key allows the user to take a picture of the

home screen.

3.6 LogFile — LogFile can be turned on or off. LogFile records all of the data the

AGV is processing into a .CSV file.

3.7 Advanced — The Advanced key is currently for Altronic Factory Use Only. This

key allows for the change of the AGV5-xL characteristics.

3.8 Help — The Help key displays the terminal program version and date

3.9 Exit — The Exit key exits out of the program.

3.10 Control Loop Parameters — The Control Loop Parameter section of the home

screen displays the current limits the AGV5 has to operate within.

3.11 Demand (D) — The Demand (D) graph displays in percent the signal the GPN

control panel is requesting the AGV5 to achieve. This D value is the same as the

mA D value displayed on the Next screen of the GPN2020.

3.12 Sensor (S) — The Sensor (S) graph display in percent where the AGV5 is in

reference to the D value. The S value is derived from the RGP Mixer sensor. The

S value in the terminal program is not the same as the S value displayed on the

NEXT screen of the GPN2020.

3.13 Valve Positon — The Valve Positon graph displays in percent the position of the

AGV5 actuator.

3.14 Valve Drive — The Valve Drive graph displays in percent the amount of energy

being sent to the voice coil to move the valve.

GTI+ AGV5 Terminal Program IOM 1-15