Altronics Micron T 2445 Kullanım Talimatları - Sayfa 2

Elektrikli Alet Altronics Micron T 2445 için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Altronics Micron T 2445 3 sayfaları.

30W Micron Soldering Iron
CAUTION:
DO NOT WORK ON LIVE CIRCUITS
Before working on any mains powered equipment, make sure that it is turned off, and the mains plug
is removed from the power point. You must not undertake work on live parts.
DO NOT USE IF DAMAGED
If the power lead becomes damaged or seems faulty, discontinue use immediately. Seek the
assistance of an authorised service technician at the place of purchase to fix anything damaged.
HIGH TEMPERATURES
Soldering irons operate at high temperatures and can easily burn the skin and/or objects. Do not
touch the tip and heater at any time and keep it a safe distance from inflammable materials while the
unit is on, or while cooling after switching off. Please allow a sufficient time for it to cool before changing
tips.
MAINTENANCE AND GENERAL CLEANING:
If supply cord is damaged in anyway it must be replaced immediately, to avoid a hazard. Only a service
agent or suitably qualified person must carry out this work.
The iron may be cleaned with a damp cloth using small amounts of liquid detergent. Never submerse the
iron in liquid or allow any liquid to penetrate the case.
HOW TO SOLDER:
Prior to soldering remove any dirt, rust or paint on the part you wish to solder.
1. Heat the part with the soldering iron.
2. Apply rosin-based solder to the part and melt it with the soldering iron. Note: When using non-ros-
in-based solder, be sure to apply a soldering paste to the part before applying the solder.
3. Wait for the solder to cool and harden before moving the soldered part.
CAUTION:
• Handle the heated soldering iron with extreme care, as the high temperature of
the iron can cause fires or painful burns.
• The first time you use the soldering iron, It man smoke slightly as the heating ele-
ment dries out. This is normal and should only last for approx. 10 minutes.
• Never file the specially-plated tip.
TIP REPLACEMENT AND DRESSING:
Note: Tip replacement or cleaning should only be done when the iron is at room temperature.
The tip can be changed or replaced by unscrewing the knurled nut barrel assembly. It is essential that
the iron is switched off and allowed to cool before and after this operation, as damage may result if the
iron is left on without the tip inserted.
After removing the tip, blow out any remaining oxide dust that may have formed in the tip retaining area
of the barrel. Care should be taken to avoid getting dust in your eyes. Replace the tip and tighten the
knurled nut barrel assembly using only hand pressure. Pliers should only be used to tighten the nut if
loosening occurs when the iron is hot. Care should be taken not to over tighten the nut, as this may dam-
age the element.
1.
2.
3.
T 2445
DO NOT FILE TIP