dji M100-ZENMUSE X5 Series Kurulum Kılavuzu - Sayfa 10
Dronlar dji M100-ZENMUSE X5 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. dji M100-ZENMUSE X5 Series 15 sayfaları. Gimbal installation kit
Sayfayı Yazdır
DJI M100-ZENMUSE X5 Series Gimbal Installation Kit
Mounting the Battery Compartment
1. Mount the battery compartment (with the metal terminals facing the tail of the aircraft) onto
the upper plate's mounting rails. Adjust the aircraft's center of gravity by moving the battery
compartment along the mounting rails and then tightening the four screws (M2.5x5).
2. Connect the Aircraft Status Indicator cable to the 6-pin port.
3. Connect the Flight Controller's power and signal cables to the 4-pin and 6-pin ports respectively.
4. Connect the lower plate's CAN cable to the CAN1 port.
Aircraft Status Indicator
Cable Port (6-pin)
The 6-Pin port with a yellow sticker is reserved. DO NOT connect any cables to this port.
Pull the above cables through the opening behind the battery cover, towards the nose of
the aircraft, before connecting them.
10
©
2016 DJI. All Rights Reserved.
CAN1 Port (5-pin)
Port for the Flight Controller
Power Cable (4-pin)
Port for the Flight Controller
Signal Cable (6-pin)