Arthur Grillo DPC200 Manuel - Sayfa 4
Kontrolör Arthur Grillo DPC200 için çevrimiçi göz atın veya pdf Manuel indirin. Arthur Grillo DPC200 7 sayfaları. Differential pressure controller, low pressure sensor with pi-control-mode
Ayrıca Arthur Grillo DPC200 için: Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum ve Kullanım Kılavuzu (14 sayfalar)
Sayfayı Yazdır
Mounting
The differential pressure controller DPC 200 is designed for wall mounting.
Installation must be done vertically.
The connection of the pressure lines is performed with plastic tubing, inner diameter ø5 mm and ø6 mm.
Device is position depended, therefore it is important that the assembly is vertical.
Operation
Start up:
- The device must be mounted vertically.
- All connections must be connected in accordance with this manual.
- The supply voltage must be controlled.
Factory setting in the delivered state:
The DPC200 is delivered with the following factory settings:
Operating mode:
Zero point:
End point:
Setpoint 1:
Setpoint 2:
Max. Voltage:
P-parameter:
I-parameter:
k-factor:
controlling mode:
measuring mode
adjusted to measuring range
adjusted to measuring range
about 75% of the measuring range
about 25% of the measuring range
maximum output voltage: 10,0 V
50
3,15
70
normal
4
T1 - Button 1
T2 - Button 2