ARTHUR HOLM Dynamic DB2 Montaj Kılavuzu - Sayfa 12

Monitör ARTHUR HOLM Dynamic DB2 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. ARTHUR HOLM Dynamic DB2 13 sayfaları.

OPTION 3

- Veneer thickness and machining must be the specified in the "Pattern Hole" document.

- Veneer material can't be metallic.

1. Check if the Veneer fits perfectly with the monitor. To join both parts correctly it is important that the two surfaces

are touching each other in the whole length. If there is a gap between the Veneer and the monitor, check if the hole

depth in the Veneer is correct. To adjust them better the head of the cyllinder can be gently filed

2. Clean the top surface of the metal monitor housing and the

bottom surface of the Veneer.

3. Glue the Veneer. Double-side tape or glue can be used

(depending on the kind of materials are going to be jointed).

The total thickness of the Veneer + glue used can't be thicker

than 5,25mm [0,2].

Veneer Guide (Optional)

The pressure applied

must not exceed 1 Kg

evenly distributed on

monitor surface.