Fitness Technology 400 Series Manuel - Sayfa 3

Fitness Ekipmanları Fitness Technology 400 Series için çevrimiçi göz atın veya pdf Manuel indirin. Fitness Technology 400 Series 11 sayfaları. Performance force plate

Sayfayı Yazdır
Fitness Technology 400 Series Manuel
FORCE PLATE 400 Kg Capacity
FRONT OF PLATFORM
Load Cell Wiring
The four Load Cells connect into the XPV7 Electronics Module are colour coded on the
load cell cables at the terminal blocks for ease of wiring, they are as follows
Load Cell
1.
Load Cell
2.
Load Cell
3.
Load Cell
4.
The wiring connection for each individual load cell is as follows.
Sig + White
Sig - Green
Ex- Black
Shield (Heat shrink - wire colour may vary)

Installation:

1.
Carefully unpack the platform by lifting it out the end of the transport carton.
Make sure all items are present. (Report any discrepancies immediately.)
2.
Place the platform onto a flat stable surface.
3.
Install each foot into the load cell holes on the four corners of the platform by
rotating the feet to the right. (right hand thread) Adjust height as show below.
4.
Connect the USB communication cable as shown below by removing the plug
allowing access to the communications port. (See photos below)
5.
The Platform is now ready for use.
6.
Install the communications software and the processing software following the
instruction for each module
7.
The XPV7 PCB Electronics Module will automatically identify any cable faults.
Should this happen make sure the communication cables are properly installed.
If communication failure continues, then replace the USB cable.
8.
For any other problems contact our office for further instructions.
Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia
Tel: +61 8 8331 9229
Copyright: Fitness Technology, Adelaide, Australia 21
FORCE PLATE 1000 Kg
Capacity
Blue
Heat - Shrink shroud as per next page
Green
Heat - Shrink shroud as per next page
Red
Heat - Shrink shroud as per next page
Yellow
Heat - Shrink shroud as per next page
Ex+ RED
Note: Green and White wires maybe reversed.
Mob: 0418 815 400.
Terminal
Block is not
on 400 S Plate
www.fittech.com.au
st
March 2005.
Issue 2.00, 21st Aug 2008
3