Cleco Tools CellCore P2402KA Hızlı Kurulum Kılavuzu - Sayfa 10
Kontrolör Cleco Tools CellCore P2402KA için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Cleco Tools CellCore P2402KA 16 sayfaları. Data transmission
Sayfayı Yazdır
3
Setting up the mPro200GC-AP
EN
For all other settings, default values are assigned, which can not be changed.
If the PC can not establish a connection to the controller, then the settings can be made via a monitor
connected to the controller.
1.
2.
3.
4.
5.
3.3
Configuring tool RF settings with the PC
1.
Connect the tool to the PC via a Micro B USB cable.
Abb. 3-2: LiveWire Utilities
2.
Switch on the tool.
3.
Determine the serial interface (COM port) for the driver in the device manager for the PC.
Abb. 3-3: Device manager
4.
Starting the LiveWire RF Configuration program under the Apex Tool Group.
Abb. 3-4: Starting the LiveWire RF Configuration program
5.
For an IRDA Connection, select the serial interface (COM port) for the driver.
6.
Select <Identify> to read out the specific data of the WLAN module.
10
Connect a monitor via a VGA connection, as well as a keyboard and a mouse, to the controller.
→ The software user interface for the controller appears on the screen.
Select Navigator > Utility > System Settings > Radio Frequency (RF) Configuration LiveWire/Cell-
Core.
Open the Wireless AP Configuration tab.
Carry out the desired settings for the configuration of the access point.
Press <Apply> to save the changes.
CCBA, CCBP
P2402KA | 2019-05
LiveWire Utilities
Micro B USB cable
Apex Tool Group