Cutlass Fasteners LBS-075-T Manuel - Sayfa 6

Kaynak Sistemi Cutlass Fasteners LBS-075-T için çevrimiçi göz atın veya pdf Manuel indirin. Cutlass Fasteners LBS-075-T 19 sayfaları.

Sayfayı Yazdır

Temperature: LED red...temperature

inside Classic exceeds 80ºC.

Chargeing cycles will be longer due to

the elevated temperature.

Main Switch: LED green...Classic is

switched on.

Power: LED green...Classic is

connected to power supply and

turned on.

Blocked: LED red...the gun has not

been withdrawn after welding stud.

Residual voltage may have been

greater than 36 volts.

The Main Switch and the following LED‟s must light up when CLASSIC is turned on...

a) Power LED

b) Capacitor charge LED...lights up red briefly and green when CLASSIC is ready.

c) Contact light...when stud in gun is touched to workpiece (grounds must be connected).

d) Hold the gun in the air and pull trigger...trigger LED should illuminate.

Solenoid light will not come on with PKM-1B connected. Solenoid light only illuminates

when optional PHM-1A GAP weld gun is connected.

Cutlass Fasteners, Inc.

83 Vermont Ave., Unit 6, Warwick, RI 02888

Tel: (401) 732-6333 Fax: (401) 732-6336

cutlass-studwelding.com

CLASSIC+ CD MANUAL

INDICATORS AND SYMBOLS

START CHECK

email:

[email protected]

Stud Welding...



Fasteners



Equipment



Service

Capacitor charge status:

LED red....capacitors charging. LED

green...capacitors charged.

LED off ...capacitors discharging.

Potentiometer: For setting capacitor

charge.

Trigger: LED green...trigger button is

pressed to start weld sequence.

Solenoid: LED orange...PHM-1A

weld gun is connected

Contact:: LED orange...complete

weld circuit...stud is connected to

workpiece.

PAGE