3M 710 Talimatlar Kılavuzu - Sayfa 12

Projektör 3M 710 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. 3M 710 20 sayfaları. Splicing rig
Ayrıca 3M 710 için: Broşür ve Teknik Özellikler (4 sayfalar), Teknik Özellikler (4 sayfalar)

Sayfayı Yazdır
3M 710 Talimatlar Kılavuzu
6.0 Crimping Bridge/Splice Module Combinations with the Bridge Module
to 3M 710-BSP Splice Presser
6.1 Properly position the two modules or the cap/module
combination to be pressed together, and pre-crimp
them as much as can easily be done by hand.
6.2 Preset rough open jaw height by using the height
adjustment nut and the adjustment guide grooves.
Top groove: Bridge pressing
Bottom groove: Cap pressing
Note: Make final adjustment using the height adjustment
nut as required.
6.3 When pressing a 710 bridge module onto a 710
splice or half-tap module, insert the module
combination between the jaws of the 3M 710-BSP
Presser, cap first, with the 710 splice or half-tap
module flush against the lower jaw of the tool. Insert
the module combination until the cap rests firmly
against the back wall of the lower jaw.
Height
Adjustment
Nut
1
Adjustment Guide
Grooves
78-815-304--E