3M 710 Manuel d'instructions - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} 3M 710. 3M 710 20 pages. Splicing rig
Également pour 3M 710 : Brochure & Specs (4 pages), Spécifications (4 pages)

Imprimer la page
3M 710 Manuel d'instructions
6.0 Crimping Bridge/Splice Module Combinations with the Bridge Module
to 3M 710-BSP Splice Presser
6.1 Properly position the two modules or the cap/module
combination to be pressed together, and pre-crimp
them as much as can easily be done by hand.
6.2 Preset rough open jaw height by using the height
adjustment nut and the adjustment guide grooves.
Top groove: Bridge pressing
Bottom groove: Cap pressing
Note: Make final adjustment using the height adjustment
nut as required.
6.3 When pressing a 710 bridge module onto a 710
splice or half-tap module, insert the module
combination between the jaws of the 3M 710-BSP
Presser, cap first, with the 710 splice or half-tap
module flush against the lower jaw of the tool. Insert
the module combination until the cap rests firmly
against the back wall of the lower jaw.
Height
Adjustment
Nut
1
Adjustment Guide
Grooves
78-815-304--E