3M 710 Manuel d'instructions - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} 3M 710. 3M 710 20 pages. Splicing rig
Également pour 3M 710 : Brochure & Specs (4 pages), Spécifications (4 pages)

Imprimer la page

7.3 Wrap the group to be spliced with the conductor

group holder. Dress the pairs over the colored peaks

with the conductor ends exiting towards the color

code guide. Do not pull the conductors tight to the

back of the connector. Use the error tester tool to

check for correct conductor placement.

7.4 Spread the conductors around the "T" bar without

disturbing them in the module body. Pull the "T" bar

up above the module body. Push the "T" bar forward

and down until contact is made with the conductors.

Pull the handle down to the stop, seating and cutting

the excess conductors in the module body. Remove

the excess conductors. Engage the handle into the

retaining clip, pull the "T" bar up, and place into the

open position.

7.5 Place a cap on the module body. Use finger pressure

to push down the cap to pre-engage it to the module

body. The cap latches should face the color code

guide. Pull the "T" bar up above the cap. Push the

"T" bar forward and down until contact is made with

the cap. Pull the handle down to the stop, seating the

cap into the module body. Engage the handle into the

retaining clip, pull the "T" bar up, and place into the

open position.

7.6 Remove the bottomless module from the splicing rig.

The 25-pair bottomless module is complete.

78-815-304--E