ALUZ ZIBI A1 Series Kurulum Talimatları Kılavuzu - Sayfa 7

Aydınlatma Ekipmanları ALUZ ZIBI A1 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. ALUZ ZIBI A1 Series 11 sayfaları. Surface zuco pivot bios illuminated
Ayrıca ALUZ ZIBI A1 Series için: Kurulum Talimatları Kılavuzu (12 sayfalar), Manuel (11 sayfalar), Manuel (13 sayfalar), Manuel (11 sayfalar)

Sayfayı Yazdır

Measure area where luminaire will be installed. Use a laser line to

create a reference line along installation area, ensuring consistent

alignment of mounting clips. Mark location where each mounting

clip will be installed along reference line.

Mark location where mounting clips will be installed.

Note: The number of required mounting clips differs for dry and wet

location products. Verify number of mounting clips is appropriate

for installation environment before installing. Do not install

luminaires with inadequate number of mounting clips.

Lay mounting clips along reference line and pre-drill using an

appropriate drill bit for surface and screw size.

Recommendation: 8/32 x 1" countersink screw.

Note: Allow 1/4" clearance for lateral expansion of assembled

mounting clips. Only install mounting clips on flat, even surfaces.

Each luminaire segment has a male and female end used for

continuous connections. Lay out each segment next to the

mounting clips where they will be installed. Position the segments

as follows: power lead end, female end, male end, and so on.

Ensure segments are aligned with mounting clips per the mounting

diagrams. Make any necessary adjustments to mounting clip

positions, then screw mounting clips to surface.

Note: Allow 1/4" clearance on each side of mounting clip to account for

lateral expansion. Only install mounting clips on flat, even surfaces.

Snap luminaire segments into mounting clips. Position each

segment end with a continuous connection end halfway across the

mounting clip.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

[email protected]

A1 Series | Surface

ZUCO Standard BIOS Illuminated

(A1-ZUCO-STN-BIOS)

866.ALUZ.LTG | 714.535.7900

Snap the next segment into mounting clips, then slide towards the

previously mounted segment. Ensure female and male pins are

aligned before applying force. Push segments together until they ﬁ t

snugly with no gaps.

Continue mounting and connecting segments until entire run has

been mounted.

Perform a continuity test before connecting to power source.

Refer to Continuity Test for details.

If applicable, install End Caps at the end of each run. Feed the

power lead through end cap exit and connect to power source.

Page 7 of 11

Dry Location Mounting

(Terminal Connection)

Installation Instructions

8 / 9 / 2023 / Rev 0