DNP IDW520 Hızlı Başlangıç Kılavuzu - Sayfa 5

Dijital Kamera DNP IDW520 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DNP IDW520 17 sayfaları. Id photo system
Ayrıca DNP IDW520 için: Başlangıç Kılavuzu (17 sayfalar)

Sayfayı Yazdır

IDW520 Photo ID System

Set Up your Printer

• Unpack the printer. Remove any

packaging foam or tape from the

outside of the printer.

• Connect your printer. Make sure

your printer is powered OFF. Connect

a USB cable to the type-B (small)

USB port (yellow circle) and to the

rear bottom console port.

• Connect the power cord to the printer

(blue circle) and plug it into a wall

outlet.

• Power ON the printer.

Install the Paper

• Prep the paper compartment. Remove the scrap bin and set it aside.

Remove the paper spools from the printer, located behind the scrap bin.

Note: The first time you set up your printer, make sure there are no spacers

on the paper spools. Rotate the spacer to unlatch it, compress the paper

spool tensioners, and slide the spacer off the spool. Repeat for the other

spool. The spacers are not used with the IDW paper 4.5" paper rolls.

• Mount the paper roll onto the paper

spools. Make sure the paper roll is oriented

so that the leading edge of the paper roll is

coming over the top of the paper roll and

directed towards the front and bottom of the

paper roll.

• Set the paper in the printer. Place the

mounted paper roll into the printer paper

compartment. Remove the seal on the paper.

• Feed the paper into the printer. Feed the

paper so that the paper comes over the top

of the roll and into the bottom of the printer

paper compartment. Continue feeding the

paper until the printer beeps. The ERROR

LED changes from flashing red and orange

to flashing red.

• Replace the scrap bin. Reset the scrap bin

in the printer.