ACPro 2PAMSH09A-17 Kullanıcı Kılavuzu - Sayfa 8

Klima ACPro 2PAMSH09A-17 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ACPro 2PAMSH09A-17 16 sayfaları. Single-zone ductless mini-split system

Airflow Direction Control

• Adjust the air flow direction properly. Failure to do so
may cause discomfort or uneven room temperatures.
• Adjust the horizontal louver using the remote control.
• Adjust the vertical louver manually.
Adjusting vertical air flow (Up/Down)
Perform this function while the unit is in operation. Use
the remote control to adjust the vertical air flow
direction. The horizontal louver can move slightly for
each press or continuously swing up and down
automatically. Please refer to the Remote Control
Operation Manual for details.
Adjusting vertical air flow (Left/Right)
• Move the deflector rod manually to adjust the air flow
in the direction you prefer.
IMPORTANT: Do not put your fingers into the panel
of the blower and suction side. The high-speed fan
inside may cause injury.
CAUTION
• Do not operate the air conditioner for long periods
with the air flow direction set downward in cooling or
dehumidifying mode. Doing so may cause
condensation to occur on the surface of the horizontal
louver, resulting in moisture dropping onto the floor
and/or furnishings.
• After a quick restart, the horizontal louver may remain
static for approximately 10 seconds.
• Open angle of the horizontal louver should not be set
too small as Cooling or Heating performance may be
reduced due to an air flow area that is too restricted.
• Do not move the horizontal louver manually. Doing so
will result in the horizontal louver being out of sync.
Should this happen, please cease operating the unit,
power down the unit for a few seconds, then power
the unit back up to restart the air conditioner.
Page 5