Akoma Pet Products Hound Heater Manuel - Sayfa 2

Isıtıcı Akoma Pet Products Hound Heater için çevrimiçi göz atın veya pdf Manuel indirin. Akoma Pet Products Hound Heater 4 sayfaları.

ELECTRICAL SAFETY INFORMATION

This heater is for use with 120 volts.

The cord has a plug as shown at A in the diagram.

An adapter as shown at C is available for

connecting three-blade grounding-type plugs to

two-slot receptacles.

The green grounding plug extending from the

adapter must be connected to a permanent

ground such as a properly grounded outlet box.

The adapter should not be used if a three-slot

grounded receptacle is available.

If an extension cord is used, it needs to be a minimum of 18 gauge wires and

it must have a 3 prong grounded plug end. Make sure the connections are

elevated off the ground, and are not able to come in contact with water, and

plugged into a GFCI outlet.

OPERATING INSTRUCTIONS

The Hound Heater™ must be properly installed before it is used.

Set the thermostat to the desired temperature in the pet house. By turning

the thermostat knob clockwise, this will increase the temperature setting of

the Hound Heater. When you turn the thermostat clockwise you will hear

a faint click. The unit will turn on and run at maximum power until that

chosen temperature is reached.

Approximate settings are as follows:

LOW - MEDIUM is approximately 35F-50F (1C - 10C)

MEDIUM - HIGH is approximately 50F-80F (10C - 26C)

The Hound Heater™ pet house furnace is powered by a long lasting 300

watt heating element.

Because all dog houses are different sizes, shapes, insulation values,

with varying outside temperatures, etc., reaching the desired

temperature will vary greatly. It is EXTREMELY important that your pet

house be insulated and preferably have a door/flap.