100FIT 30T Kullanım Kılavuzu - Sayfa 13

Koşu Bandı 100FIT 30T için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 100FIT 30T 19 sayfaları.

6.Daily maintenance

Important reminder

.Do not use sandpaper and solvents to clean the treadmill.

.The controller part of the treadmill should not be directly exposed to sunlight or moisture to

avoid damage.

.Always check and lock all parts of the treadmill. Damaged parts must be replaced

immediately.

.The running belt is the most vulnerable part of the operation. Please replace it in time when

the operation wear is severe.

Adjust running belt

Adjusting the running has two functions: elastic adjustment and adjusting the

1.1

center position of the running belt. The running belt has been adjusted at the factory,

but after use, the running belt will be stretched and will deviate from the center

position plate causing the running belt to rub the decorative strip and The rear cover is

damaged, and it is normal for the running belt to be stretched during use. If the

running belt slips or is not smooth when you use the treadmill, you can adjust the

tightness of the running belt to improve it.

How to adjust the running belt?

1.2

）

1 Insert a 5mm Allen wrench into the adjustment screw on the left side of the walking

belt, and turn the wrench 1/4 turn clockwise to adjust the rear roller to tighten the

。

running belt

）

2 Repeat step 1 to adjust the right screw. Make sure that the adjustment screw

rotates the same distance, so that the rear roller will be adjusted parallel to the frame

）

3 Repeat steps 1 and 2 until the running belt does not slip

）

4 Note that the running belt cannot be adjusted too tightly, as this will damage the

running belt, increase the pressure of the front/rear rollers, cause damage to the roller

bearings, etc., produce abnormal sound or other problems, if you want to reduce the

tension of the running belt, please reverse Turn the wrench with the hour hand, and

。