Etac Molift Mover 180 Operatör El Kitabı - Sayfa 4
Kaldırma Sistemleri Etac Molift Mover 180 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Etac Molift Mover 180 16 sayfaları. Electric patient lift
Ayrıca Etac Molift Mover 180 için: Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (6 sayfalar)
Sayfayı Yazdır
General safety information
General
Before the Molift Mover 180 can be started
up, operator must make sure that the lift is in
good working order, in terms of both safety and
operation.
The lift must be taken out of operation immediately
if faults affecting safety and reliability are identified.
Molift Mover 180 has an SWL (Safe Working
Load) of 182 kg. This means that it is built
and tested to lift patients weighing up to 182
kg. When using accessories (e.g. slings and
stretchers) with a lower SWL, the lowest SWL
will apply.
The lift may tip over if used incorrectly! Make
sure you are familiar with the instructions
before you attempt to lift anyone.
The lift must not be used on sloping floors or
ramps.
Use the push handle when manoeuvring the
lift; do not pull the patient or the lifting arm.
Medical electrical equipment requires
special precautions regarding electro-
magnetic compatibility (EMC). Portable or
mobile radio communication equipment
may affect the medical electrical equipment,
and should be kept minimum 25 cm (10
inches) from the lifters electronics.
Safety instructions
• The lift has an overload protection function to
prevent it from lifting more than 182 kg.
• The lift is also designed such that it cannot
crush patients if it is lowered too far.
• Pressing the emergency stop button shuts off
the power supply straight away and stops the
lift.
• The lift features both an electrical and a manual
emergency lowering function.
• The lift has a light to indicate when it needs
service.
Page 4 of 16
Assembly and dismantling
Unpacking
• The lift is delivered in a cardboard box. Make
sure that the packaging is intact upon delivery.
If it is not intact, check the contents of the box; if
there is evidence of damage inside, contact your
Molift representative straight away.
• The box contains a complete Mover lift unit,
including hand control, battery and battery
charger.
Assembly
• Roll the chassis out of the cardboard box.
• Charge the battery.
N.B. The battery must not be in the holder on the
column during installation.
• Slide the column into the column holder on the
chassis as shown in the pictures below.
• Lock the lift column in place by fastening the
two Allen screws in front and rear of the chassis
as shown in the pictures below.
Screws will ensure that the column cannot
be pulled upwards. Do not use lifter unless
screws are in place.
• Plug the hand control into the very bottom of
the battery holder. The hand control has a hook
so that it can be hung on the bracket at the top
of the column.
BM08101 Molift MOVER 180 English - Rev C 19.12.2013